A&D GF-30K - External Dimensions

104 pages

Save Page as PDF

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

93

20-1. External Dimensions

Unit: mm

Table of Contents

Default Chapter3
- Table of Contents3
1 Introduction5
- About this Manual5
- Basic Operation5
- Features5
- Compliance6
2 Unpacking and Installing the Balance8
- Installing the Balance9
3 Precautions9
- Before Use9
- During Use10
- After Use11
- Power Supply11
4 Display Symbols and Key Operation12
- Smart Range Function13
5 Weighing Units14
- Units14
- Changing the Units17
6 Weighing18
- Basic Operation (Gram Mode)18
- Counting Mode (PCS)19
- Percent Mode (%)21
- Animal Weighing Mode (Hold Function)21
- Accumulation Function22
7 Weighing Speed Adjustment / Self Check Function24
- Weighing Speed Adjustment24
- Self Check Function with Response Adjustment for the GX-K Series25
- Self Check Function for GF-K Series25
8 Calibration26
- Calibration Group26
- Automatic Self Calibration for the GX-K Series27
- One-Touch Calibration for the GX-K Series28
- Calibration Using an External Weight29
- Calibration Test Using an External Weight30
- Correcting the Internal Mass Value of the GX-K Series31
9 Function Switch and Initialization33
- Permit or Inhibit33
- Initializing the Balance34
10 Function Table35
- Details of the Function Table36
- Description of the Class "Environment, Display39
11 ID Number and GLP Report54
- Setting the ID Number54
- GLP Report55
12 Data Memory58
- Notes on Using Data Memory58
- Data Memory for Weighing Data59
- Setting the Function Table60
- Data Memory for Calibration and Calibration Test62
- Data Memory for Unit Mass in the Counting Mode63
- Data Memory for Comparator Settings66
- Data Memory for Tare Value69
  - Data Memory: Quick Selection Mode72
- Data Memory: Confirmation and Storage Mode73
13 Underhook75
14 Programmable Unit76
15 Density Measurement77
16 Standard Input & Output Interface81
- RS-232C and External Contact Input81
- Connection to Peripheral Equipment83
17 Commands85
- Command List85
- Acknowledge Code and Error Codes86
- Control Using CTS and RTS87
- Settings Related to RS-232C87
18 Maintenance88
- Treatment of the Balance88
19 Troubleshooting89
- Checking the Balance Performance and Environment89
20 Specifications93
- External Dimensions95
- Options and Peripheral Instruments96
21 Terms/Index98
- Terms98
- Index100

Related product manuals

Preview: A&D GF-1200