A&D TM-2441 - Preparing the Recorder for Use; Battery Installation and Replacement

21
To adjust the clock.
To set the monitor function of A-BPM.
Step 1. Set the AUTO switch to "OFF".
Step 2. If the indication of the display is hidden, press the START/STOP
or EVENT switch to return to the display of waiting mode.
Step 3. While pressing and holding the START/STOP switch,
press and hold the EVENT switch for 6 seconds or more.
Display is displayed on the OLED display.
Step 4. Operation switches are as follows:
Refer to "
8.2.2. The Clock and the Monitor Function of Measurement "
EVENT switch
.................
Change the current parameter.
START/STOP switch
......
Decision, next item, end of settings.