A&D TM-2441 - S-BPM Programs

55
8.4. S-BPM Programs
The initial settings can be configured using the following methods.
The method to use switches on the recorder.
The method to use dedicated peripheral that is connected to the
recorder using the USB cable.
Procedure of operation using switches
Step 1. Set the AUTO switch to "OFF".
Step 2. While holding the / switch press and hold the
START/STOP switch for 3 seconds or more.
is displayed on the LCD panel.
Step 3. Select S-BPM program using the following switches.
Program : OBP , AOBP, HBP, ANBP, ASBP
/ switch
......................
Change of the current parameter.
START/STOP switch
........
Decision, next item.
Step 4. Specify each item (Measurement count, Interval time, Start
time and Start time of alarm) using the following switches.
/ switch
......................
Change of the current parameter.
START/STOP switch
........
Decision, next item, end of settings.
Step 5. After completing settings, S-BPM clock is displayed.
Do not remove batteries while charging the settings.
If batteries are removed, input settings again.