62
How to stop or suspend the measurement
Press the START/STOP switch to stop blood pressure
measurement. An error code is stored in the memory. Blood
pressure is measured again after 120 seconds.
Concerning of A-BPM and ANBP and ASBP mode of S-BPM,
only the current blood pressure measurement can be suspended
and the "1 scope" is performed at the next start time. Set the
AUTO switch to "OFF" to suspend A-BPM.
Remove the cuff if the current blood pressure measurement can
not be stopped using the START/STOP switch.
Press the START/STOP switch to stop the measurement.
The "1 scope" is still performed at the next start time for
A-BPM and the ANBP and ASBP modes of S-BPM.
When a pain of the arm or unexpected condition occur, stop
the measurement, remove the cuff and consult the doctor.
Set the AUTO switch to "OFF" to suspend A-BPM.
Set the AUTO switch to "ON" to resume A-BPM automated
measurement. The mark is shown on the LCD panel and OLED
display. The recording of data continues until switched to "OFF".
How to use manual measurement during A-BPM
Step
1.
If the indication of the OLED display is hidden, press the
START/STOP or EVENT switch to return to the display of
A-BPM waiting mode.
Step
2.
Press the START/STOP switch to immediately measure the
blood pressure during A-BPM.
Step
3.
Measurement results are stored in the memory.
When the START/STOP switch is pressed during
measurement, the measurement is suspended.
To Next Page
Loading...
