Page 10 01/2007 AMT/PTD/PBX/0020/2/4/EN
Chapter 8: Checking the installation
This chapter describes the preliminary operations common to both the NeXspan C/S/L/D,
NeXspan 50 and NeXspan 500 ranges before the DECT installation is programmed and put in
service.
Chapter 9: Programming for the NeXspan C/S/L/D range
This chapter describes the programming steps to put in service the integrated DECT service for
NeXspan C/S/L./D
Chapter 10: Programming for the NeXspan 50/NeXspan 500 range
This chapter describes the programming steps to put in service the integrated DECT service for
NeXspan 50 and NeXspan 500 PBXs.
Chapter 11: Multi-site programming
This chapter describes the specific programming steps to put in service the integrated DECT
service for a multi-site network.
1.2 Audience
This document is for installers whose tasks are to:
• carry out a study into positioning base stations, and system traffic flow,
• connect base stations to the distribution frame,
• start up and put the DECT system in service.
To Next Page
Loading...
Need help?
General
