AMT/PTD/PBX/0020/2/4/EN 01/2007 Page 183
10.8 Declare the DECT parameters
Declare the DECT parameters in the MMC XLIGAB, object "radio zones" sub-object "DECT
parameters".
The SARI number is the same as the PARI number. The PARI number is unique.
• RS and Rand F: maximum 9 digits.
2 random values (must not be the same) registered in the mobile by the PBX when the mobile
was registered on the DECT network. From this point onwards, the PBX regularly checks the
values registered in the mobiles (the values are calculated from these two parameters) in
order to authorise or refuse use of the DECT network.
Enter a value lower than 4294967295 (FFFF FFFFh). The value of the random number has
no significance. However, in a multi-site configuration the number must be identical in all
locations where the mobiles are to be registered.
• LLP Radst prefix: 4 digits maximum, 999 is the default.
The base stations are connected to the PBX via an S0 Basic Rate Interface. One PLL (D
channel) is used for signalling and downloading to the base stations. PLL directory numbers
are comprised of digits recorded in this parameter followed by the base station declaration
order number.
Example: 999000, 999001, 999002, etc.
TELEPHONE SUBSCRIBERS
Objet=Radio Restrictions Radio Topic=DECT Parameters Action=Display
--------------------------------------------------------------------------------
PARI 1=0268652584
PARI 2=..........
PARI 3=..........
PARI 4=..........
RS=0000001515
Rand f=0000001789
synchronization delay Bit P0=1..
LLP Radst prefix=999.
Company profil. SARI Company profil. SARI
--------------- ---------- --------------- ----------
=0 =0268652584 =. =..........
=. =.......... =. =......
To Next Page
Loading...
Need help?
General
