To Next Page

To Previous Page

Page 42 01/2007 AMT/PTD/PBX/0020/2/4/EN

2.4.2 Configuring an M910/M915 mobile terminal

Registering an M910/M915 mobile terminal

It is important to follow the procedure below when registering the M910 for the first time.

On the mobile terminal, the line "Register" is displayed. Press the

key, select System

using the keys and confirm with

Select Register using and confirm with

The line "PARK? : " appears. Do not make any entry. Press

The line "BS-PIN" appears. Enter the mobile terminal number (4 digits) and confirm with

The line "Name" appears. Enter the name of the PBX on which the mobile terminal has just

been registered and press

to confirm.

The line " Int No." appears. This is a user information line. The number of the mobile can be

entered here, for example, or the number to be called if the mobile is lost. Enter the

information and confirm with

The mobile terminal must be configured on the base station previously recorded. Select

“Menu, System, Base Station selection (choose the base station compared to the name

seized into 5)”

Note: After registering the mobile terminal, to change the PBX name and/or the Int No., use the

selection "Menu, Device, OK, Save, OK, Opt, Edit; enter PBX name, OK; enter Int No.,

OK”.

Canceling a registration

When the mobile terminal is registered on several base stations, to cancel the registration on a

non-selected base station, proceed as follows:

Press the

key, select Device using the keys and confirm with

Select Register using and confirm with

Select the base station to be deleted using the keys.

Press the

key, select Delete using the keys and confirm with

If the mobile is registered with a single base station, refer to the Installer menu.

Call rejection function

There are two options when an incoming call is received.

• The sil (silence) function removes the ring tone without interrupting the call.

• The rej (reject) function allows the calling party to suddenly hang up. When the function is

activated, a “Wait” message is displayed for 35 seconds. The mobile terminal can no longer

receive or make calls within these 35 seconds (busy tone). To seize the line after rejecting a

call, just activate the “PLD” (line seizure) key.

Aastra NeXspan C User Manual

Questions and Answers: