Aastra NeXspan C - Page 35

AMT/PTD/PBX/0020/2/4/EN 01/2007 Page 35
7 "Enter code" appears on the display
Enter the "set number + PBX registration code" and press OK .
The set displays "Please Wait".
• "Still waiting"
• "Declare base OK" or "Failed, Retry"
Stop and restart the mobile, then check to see if it is active.
Deregistering an M90x mobile terminal
1 Press the Menu key
2 Press the middle key until “Personalize” is displayed
3 Press the Personalize key
4 Press the middle key or several times until "Declare" is displayed
5 Press the Declare key
The display shows:
6 Press the or key to select the base to be deleted and confirm by pressing the OK
key
The set displays:
• (n = base number)
• Press the key: yes
The set displays:
7 Press the OK key (without entering code)
The set displays:
Stop and restart the mobile by pressing the "C" key for a few seconds but not long enough
for the display to change.
½
½
¾
¾
½
¾
¾
Declare
base number?
1 2 3 4 OK
½
½
¾
½
Delete base n
¾ no yes ½
½
Enter code
n
OK
½
½
Please Wait, then
Still waiting