ABB 2600T Series - Analog Input 2 setting (Applicable only for Differential Pressure Sensor types)

To Next Page

To Previous Page

2600T SERIES | PRESSURE TRANSMITTERS | OI/266/FF-EN REV. E

...Device Configuration/Setting through FF communication

Analog Input 2 setting (Applicable only for Differential Pressure Sensor types)

Channel  

Damping  

  

  

Calibration Unit  MPa

  

  

Output Scale Unit  MPa

Linearization  Direct

Critical Limit Low  

Advisory Limit Low 

Advisory Limit High  

Critical Limit High 

Alarm Hysteresis  

Analog Input 3 setting

Channel  

Damping  

  

  

Calibration Unit  °C

  

  

Output Scale Unit  °C

Linearization  Direct

Critical Limit Low  

Advisory Limit Low 

Advisory Limit High  

Critical Limit High 

Alarm Hysteresis  

IMPORTANT

All the above configurable parameters can be afterward modified via DD based software tools.

Other manuals for ABB 2600T Series