10 ACH580 Installation, Operation and Maintenance Manual
ACH580-01 Installation
Tools required
To install the ACH580 you need the following:
• Screwdrivers as appropriate for the mounting hardware used
, including a
T20
Torx driver for drive cover removal
• Wire stripper
• Tape measure and/or provided mounting template
•Drill
• Frame sizes R5…R9: pallet truck and hoist
• Frame sizes R5…R9: The appropriate crimping tool for power cable lugs.
• Mounting hardware: screws or nuts and bolts. The type, length and quan
tity of
hard
ware depends on the mounting surface and the frame size:
WARNING! Before installing the ACH580, ensure the input power supply to the drive
is off.
WARNING! Metal shavings or debris in the enclosure can damage electrical
equipment and create a hazardous condition. Where parts, such as conduit plates
require cutting or drilling, first remove the part. If that is not practical, cover nearby
electrical components to protect them from all shavings or debris.
Flange Mounting
Further information is in Supplement: Flange mounting kit installation,
3AXD50000201877.
Frame size Mounting hardware Qty
R1...R2 M5 #10 4
R3 M6 1/4 in. 4
R5 M6 1/4 in. 6
R6…R9 M8 5/16 in. 4
Frame size Kit
R1 3AXD50000105311
R2 3AXD50000105328
R3 3AXD50000105335
R4 3AXD50000031460
R5 3AXD50000031461
R6 3AXD50000018852
R7 3AXD50000018853
R8 3AXD50000018854
R9 3AXD50000018855
To Next Page
Loading...
