ABB ACH580 Series - Fuses; 208…240 Volt, Fuse Requirements

24 ACH580 Installation, Operation and Maintenance Manual
ACH580-01 Installation
Fuses
Note: The UL listed fuses in the table are the required branch circuit protection.
Fuses are to be provided as part of the installation.
• Fuses are not included in the purchased drive and must be provided by ot
hers.
•
Fuses with higher current rating than specified must no
t be used.
•
Fuses with lower current rating than specified may be used if they are of the sa
me
class and
voltage rating. It is the user's responsibility to verify that lower cu
rrent
rate
d fuses are compliant with local regulations and appropriate
for the
app
lication.
• Drive fuses must be used to maintain the drive UL listing. Additional protection
can be used. Refer to local codes and regulations.
208…240 volt, fuse requirements
ACH580-01-
Input
current
A
UL
Maximum
current
Voltage rating
Bussmannn type
1
UL class
AV
3-phase U
N
= 208 V
04A6-2 4.6 15 600 KTK-R-15 or JJS-15 CC or T
06A6-2 6.6 15 600 KTK-R-15 or JJS-15 CC or T
07A5-2 7.5 15 600 KTK-R-15 or JJS-15 CC or T
10A6-2
10.6 15 600 KTK-R-15 or JJS-15 CC or T
017A-2 16.7 30 600 KTK-R-30 or JJS-30 CC or T
024A-2 24.2 40 600 JJS-40 T
031A-2 30.8 40 600 JJS-40 T
046A-2 46.2 80 600 JJS-80 T
059A-2 59.4 80 600 JJS-80 T
075A-2 74.8 100 600 JJS-100 T
088A-2 88 150 600 JJS-150 T
114A-2 114 150 600 JJS-150 T
144A-2 143 200 600 JJS-200 T
169A-2 169 250 600 JJS-250 T
211A-2 211 300 600 JJS-300 T
273A-2 273 400 600 JJS-400 T
1) ABB does not require Bussmann brand fuses. Fuses which meet the appropriate UL class type,
current rating, and are rated at 600V, 200 kA may be used.