ABB ACH580 Series - Install the Drive; Install the Cable Box, Frames R1…R2

ACH580 Installation, Operation and Maintenance Manual 11
ACH580-01 Installation
3. Install the drive
Installing the drive vertically, frames R1…R4
The figures show frame R3 as an example.
1. Mark the hole locations using the mounting template included in the package. Do no
t
leave the
mounting template under the drive. The drive dimensions and ho
le
locatio
ns are also shown in the drawings in the ACH580 Hardware manua
l,
publica
tion number
3AXD50000044839.
2. Drill the mounting holes.
3. Insert anchors or plugs into the holes and start the bolts into the anchors or plugs.
Use long enough bolts to make them carry the weight of the drive.
4. Position the drive onto the bolts on the wall.
5. Tighten the bolts in the wall securely
.
In
stall the cable box, frames R1…R2
6. Remove the screw (6a) and lift the cover off (6b) from the separate cable box.
7. Attach the cable box cover to the front cover.
R1 R2 R3 R4
in. mm in. mm in. mm in. mm
a 3.86 98 3.86 98 6.30 160 6.30 160
b 12.48 317 16.42 417 18.62 473 24.37 619
Weight
IP21 (UL (NEMA)
Type 1)
lb kg lb kg lb kg lb kg
10.1 4.6 14.6 6.6 26.0 11.8 41.9 19.0
Weight
IP55 (UL (NEMA)
Type 12)
lb kg lb kg lb kg lb kg
10.6 4.8 15.0 6.8 28.7 13.0 44.1 20.0
a
b
1 2 3
×4
×4
R1…R2: M5 (#10)
R3…R4: M6 (1/4 in)
×4
4a 5 4b
×4