ACH580 Installation, Operation and Maintenance Manual 89
ACH580 E-Clipse Bypass
ACH580 E-Clipse Bypass
Installation – Drive
Follow the Installation instructions for the drive on page 8. Failure to observe the
warnings and instructions may cause a malfunction or personal hazard.
WARNING! Before you begin read Safety instructions on page 2.
WARNING! Bypass configurations (ACH580-VxR & ACH580-BxR) do not support Safe
Torque Off (STO) functionality.
Enclosure
Designation
Horsepower Range by Voltage Rating
208V 460V 575V
2
V1 1 to 3 HP 1 to 7.5 HP N/A
V2 5 to 7.5 HP 10 to 15 HP 2 to 15 HP
V3 10 HP 20 to 30 HP 20 to 30 HP
V4 15 to 25 HP 40 to 60 HP N/A
B1 1 to 7.5 HP 1 to 15 HP 2 to 15 HP
B2 10 to 25 HP 20 to 60 HP 20 to 30 HP
B3 30 to 100 HP
1
75 to 200 HP 40 to 150 HP
1) 100 HP @ 230V.
2) VCR and BCR are rated 600Y/347V unless otherwise specified. For use on a solidly
grounded Wye source only.
To Next Page
Loading...
