Start-up 93
Hints on using the assistant control panel
The two commands at the bottom of the display
(Options and Menu in the figure on the right), show the
functions of the two softkeys and located
below the display. The commands assigned to the
softkeys vary depending on the context.
Use keys , , and to move the cursor and/or
change values depending on the active view.
Key shows a context-sensitive help page.
1 – First start assistant guided settings:
Language, date and time, and motor nominal values
Have the motor name plate data at hand.
Power up the drive.
The First start assistant guides you through the start-up.
The assistant starts automatically. Wait until the control
panel enters the view shown on the right. Select the
language you want to use by highlighting it (if not already
highlighted) and pressing (OK).
Note: After you have selected the language, it takes a
few minutes for the control panel to wake up.
Select Start set-up and press (Next).
Select the localization you want to use and press
(Next).
Change the units shown on the panel if needed.
• Go to the edit view of a selected row by pressing .
• Scroll the view with and .
Go to the next view by pressing (Next).
Set the date and time as well as date and time display
formats.
• Go to the edit view of a selected row by pressing .
• Scroll the view with and .
Go to the next view by pressing (Next).
To Next Page
Loading...
