Parameters 103
Summary of parameter groups
Group Contents Page
01 Actual values Basic signals for monitoring the drive. 105
03 Input references Values of references received from various sources. 108
04 Warnings and faults Information on warnings and faults that occurred last. 109
05 Diagnostics Various run-time-type counters and measurements related to
drive maintenance.
115
06 Control and status words Drive control and status words. 116
07 System info Drive hardware and firmware information. 124
09 Pump actuals Basic signals for monitoring the application. 125
10 Standard DI, RO Configuration of digital inputs and relay outputs. 128
11 Standard DIO, FI, FO Configuration of digital input/outputs and frequency
inputs/outputs.
134
12 Standard AI Configuration of standard analog inputs. 140
13 Standard AO Configuration of standard analog outputs. 144
14 I/O extension module 1 Configuration of I/O extension module 1. 149
15 I/O extension module 2 Configuration of I/O extension module 2. 171
16 I/O extension module 3 Configuration of I/O extension module 3. 174
19 Operation mode Selection of local and external control location sources and
operating modes.
178
20 Start/stop/direction Start/stop/direction and run/start/jog enable signal source
selection; positive/negative reference enable signal source
selection.
180
21 Start/stop mode Start and stop modes; emergency stop mode and signal source
selection; DC magnetization settings; autophasing mode
selection.
189
22 Speed reference selection Speed reference selection settings; motor potentiometer
settings.
195
23 Speed reference ramp Speed reference ramp settings (programming of the
acceleration and deceleration rates for the drive).
203
24 Speed reference conditioning Speed error calculation; speed error window control
configuration; speed error step.
210
25 Speed control Speed controller settings. 213
26 Torque reference chain Settings for the torque reference chain. 224
28 Frequency reference chain Settings for the frequency reference chain. 226
30 Limits Drive operation limits. 235
31 Fault functions Configuration of external events; selection of behavior of the
drive upon fault situations.
241
32 Supervision Configuration of signal supervision functions 1…3. 251
33 Generic timer & counter Configuration of maintenance timers/counters. 254
35 Motor thermal protection Motor thermal protection settings such as temperature
measurement configuration, load curve definition and motor fan
control configuration.
262
36 Load analyzer Peak value and amplitude logger settings. 272
43 Brake chopper Settings for the internal brake chopper.
276
45 Energy efficiency Settings for the energy saving calculators. 277
To Next Page
Loading...
