12 Introduction
Target audience
This manual is intended for people who design, commission, or operate the drive
system.
Contents of the manual
This manual contains the following chapters:
• Quick start-up guide for ACS880 drives (page 15) describes the start-up sequence
of the pump control program.
• PCP/ESP control start-up (page 23) describes the start-up sequence of the pump
control program.
• Using the control panel (page 29) refers to the instructions for using the control
panel.
• PCP/ESP program features (page 31) describes the program features specific to
the progressive cavity pump (PCP)/Electric submersible pump (ESP) applications.
• Standard programposi features (page 51) describes the control locations and
operation modes as well as the program features that are not specific to PCP/ESP
applications.
• Default control connections (page 95) presents the default connection diagram of
the PCP/ESP control application.
• Parameters (page 101) describes the parameters of the drive.
• Additional parameter data (page 361) contains further information on the
parameters.
• Fault tracing (page 405) lists the warning and fault messages with possible causes
and remedies.
• Fieldbus control through the embedded fieldbus interface (EFB) (page 437)
describes the communication to and from a fieldbus network using the embedded
fieldbus interface of the drive.
• Fieldbus control through a fieldbus adapter (page 461) describes the
communication to and from a fieldbus network using an optional fieldbus adapter
module.
• Control chain diagrams (page 475) shows the parameter structure within the drive.
• Appendix: ESP with step-up transformer and sine filter (page 487) provides an
overview of ESP with step-up transformer and sine filter.
Related documents
A list of related manuals is printed on the inside of the front cover.
To Next Page
Loading...
