Quick start-up guide for ACS880 drives 17
Start-up
Safety
The start-up may only be carried out by a qualified electrician.
The safety instructions must be followed during the start-up procedure. See the safety
instructions on the first pages of the appropriate Hardware manual.
Check the installation. See the installation checklist in the appropriate Hardware manual.
Check that the starting of the motor does not cause any danger.
De-couple the driven machine if
• there is a risk of damage in case of an incorrect direction of rotation, or
•a Normal ID run is required during the drive start-up, when the load torque is higher than 20% or
the machinery is not able to withstand the nominal torque transient during the ID run.
1 – Power-up, language, date and time settings
Power up the drive.
The language selection menu appears.
Wait until the loading finishes and the Home view
appears.
Note: During the start-up, it is normal that warning
messages are displayed either in the top or main
pane of the display. The messages can be ignored
at this point. To hide any warnings displayed in the
main pane, press (Hide).
The two commands at the bottom of the display (in
this case, Options and Menu), show the functions
of the two softkeys and located
below the display. The commands assigned to the
softkeys vary depending on the context.
In the Home view, press (Menu).
The main Menu appears.
To Next Page
Loading...
