53
8 SENSOR MAINTENANCE…
Fig. 8.3 7320 200 High Range Sensor – Splitting the Flowcell
…8.2.1 Dismantling and Cleaning – Figs. 8.1 to 8.4
Note. Reassembly is the reverse of dismantling.
View from emitter end
Remove the two screws securing the
mounting plate to the angle bracket.
Remove the four stainless steel screws
holding the flowcell halves together.
Insert two of the stainless steel screws into the
holes indicated and screw them in them slowly
and evenly to push the cell halves apart.
When the O-ring seal is clear of the body,
the cell halves should separate easily.
3
2
1
To Next Page
Loading...
