ABB CL-LSR 12AC2 Series - Parameter Display and Parameter Set for a Timing Relay

Timing relays
149
1SVC 440 795 M0100
Parameter display and parameter set for a timing
relay
In the parameter display of a timing relay you can change the
mode, the time base, the time setpoint 1, time setpoint 2
(if necessary) and the enable of the parameter display.
Compatibility of AC010 with CL-LSR/CL-LST and
CL-LMR/CL-LMT: Timing relay parameter display
The CL-LSR/CL-LST and CL-LMR/CL-LMT parameter display
has been provided with new functions. The AC010
parameters are at the following points.
T1 X S +
I1 00.000
I2 00.000
T:
T1 Timing relay number 1
X On-delayed mode
S Time range in seconds
+ • + appears in the PARAMETER menu.
• - does not appear in the PARAMETER menu
I1 Time setpoint 1:
• Positive value, I7, I8, I11, I12
• Actual value T1 to T16, C1 to C16
I2 Time setpoint 2 (with timing relay with 2 setpoints):
• Positive value, I7, I8, I11, I12
• Actual value T1 to T16, C1 to C16
T: Display of actual value in RUN mode
AC010 parameter CL-LSR/CL-LST-,
CL-LMR/CL-LMT
parameter
T1 =T1
X =X
S =S
AA.BB =AA.BB
+ =+
X w g
S nAA.BBn
Ä sTRG dT1
yRES b+
T1 X S +
I1 AA.BB
I2