Startup behaviour
219
1SVC 440 795 M0100
Startup behaviour for memory module
The startup behaviour using a memory module is for
applications where unskilled personnel have to change the
memory module with the logic relay de-energized.
The logic relay will then only start in RUN mode if a memory
module with a valid program is fitted.
If the program on the memory module is different to the
program in the logic relay, the program on the module is
loaded first and the logic relay starts in RUN mode.
X Switch to the system menu.
Activate memory module startup
If the logic relay shows
RUN MODE å in the display, it
will only start up in RUN mode at power on if the memory
module fitted contains a valid program.
X Otherwise select CARD MODE and press OK.
The logic relay will start up with the program on the module.
X Press ESC to return to the status display.
h
Factory setting:
Card mode is not activated.
h
If the logic relay is protected by a password, the
system menu will not be available until the logic relay
is “unlocked” (a section “Unlock logic relay”,
from Page 199).
DEBOUNCE åÆ
P BUTTONS
RUN MODE å
CARD MODEåæ
h
Card mode is only possible with the CL-LAS.MD003
memory module. Old MD001 or MD002 memory modules
do not support this function.
To Next Page
Loading...
