114 EL3060 CONTINUOUS GAS ANALYZERS | OI/EL3060-EN REV. A
Exporting or deleting QAL3 data
Exporting QAL3 data
The QAL3 data can be exported from the gas analyzer for archiving or pro-
cessing in e.g. a spread-sheet program.
1 Click "QAL3 Monitoring" on the QAL3 monitoring home page.
2 Select the type of display on the "QAL3 Monitoring" page:
• "Zero point simple"
• "Reference point simple",
• "Zero point details"
• "Reference point details".
3 Select the type of control chart (see page 108) ("Control Chart to Dis-
play") for the desired sample component.
4 Click "Export data" at the end of the page.
The QAL3 data of the displayed control chart is exported to a text file
(.txt).
5 Open the text file or store it (if required, under a new name).
6 If required, repeat steps 2 to 5 for further control charts.
Deleting QAL3 data
1 Click "QAL3 Monitoring" on the QAL3 monitoring home page.
2 Click "Settings" on the "QAL3 Monitoring" page.
3 Click "Delete all data" in the "Data storage" window:
The following warning is displayed:
"Are you sure you want to delete all data? This operation cannot be un-
done. Ensure that all data has been exported before you continue."
4 Click "OK". The QAL3 data is deleted.
5 Exit the page by clicking "Save" or "Cancel".
To Next Page
Loading...
Need help?
General
