Page 115
© Copyright 2021 ABB. All rights reserved.
RPM Installation (Continued)
Place Bus Terminating
Resistor (405298308) on Last
Module in the Chain
for Each Bus
Mounting Holes
100K Ring Type Probes
and Connecting
Cable Shown in Figure 10-3.
CLR Assembly
(847540424)
100k
Typical GPS Load Monitoring Shunt
Connection Note: CLRs are not required
for any GPS load panel connections.
Generic Monitoring Connection
TB102
TB101
Figure 9-2: Connection of Voltage, Shunt, Transducer, and Binary Modules
Two wire and shield input
Two wire and shield output
(if not the last module)
100k
Cable tie
IN
IN
SHIELD
SHIELD
X1
To Next Page
Loading...
