ABB Galaxy Power System - AC Cable Routing Instructions; Connecting AC Conduit

Page 57
© Copyright 2021 ABB. All rights reserved.
AC Cable Routing
Caution: Follow all local codes and practices when performing the steps to connect ac to the power
system.
AC Cable Routing
Step Action
1 Clearly label the main AC circuit breaker panel, stating that installers are working in the AC cabling.
2 Check that all AC circuit breakers are turned OFF.
3 Route the AC cables to the cabinet as required by local building codes.
4 At the cabinet, route the AC cables through the access holes in the top of the cabinet.
5 Install terminal lugs (if applicable) to cables.
Connecting AC Conduit
Figure 7-1: Attaching AC Conduit
Qty Conduit
9 1”
4 1-1/2”
4 2”