ABB Galaxy Power System - Cabinet Installation Procedure Steps

Page 30
© Copyright 2021 ABB. All rights reserved.
Table 5 - A: GPS Mounting Specifications
Seismic
Zone(s)
Anchor Type
(HILTI)
Hole Size Wrench Torque
0, 1 847135720
(4) 3/8"
drop in
1/2" bit
1-9/16" deep
--
85 in·lbs
(7.1 ft·lbs)
9.6 N·m
0, 1 847135712
(4) 3/8"
self drill
-- --
85 in·lbs
(7.1 ft·lbs)
9.6 N·m
0, 1, 2 847135662
(4) 1/2"
drop-in
5/8" bit
2" deep
3/4"
216 in·lbs
(18 ft·lbs)
24.5 N·m
0, 1, 2 847135654
(4) 1/2"
self drill
-- 3/4"
216 in·lbs
(18 ft·lbs)
24.5 N·m
0, 1, 2, 3, 4 847135670
(4) 12mm
self drill
-- 19mm
720 in·lbs
(60 ft·lbs)
81.6 N·m
0, 1, 2, 3, 4 847135688
(4) 12mm
cap bolts
18mm
100mm deep
19mm
720 in·lbs
(60 ft·lbs)
81.6 N·m
Cabinet Installation (continued)
Procedure
Refer to Figure 5 - 4/5 for this procedure.
Cabinet Installation
Step Action
Position the appropriate drill template where the cabinet is to be located.
Comcode of Template, 847891280
Using a drill bit, drill anchor holes to the depths specified in Table 5 - A.
Locate the cabinet in position using two or four anchor bolts and hold - down washers.
Shim under cabinet corners to level.
Torque anchors as specified in Table 5 - A.
Secure cabinets together using the hardware provided.
Note: See H569 - 407 for more details.