Page 138
© Copyright 2021 ABB. All rights reserved.
Installing Rectifiers (Continued)
Install Rectifiers
1. Open the faceplate by sliding the black latch to the left to
release the faceplate.
2. Push the unit firmly into the shelf until seated.
3. Swing the faceplate closed until it is secured by the latch.
4. Turn on the AC breaker powering the shelf slot.
5. Following initialization of the rectifier module, verifying its
green LED and only its green LED is on.
6. If this isn’t the case, see Troubleshooting section.
Figure 13-2B: Installing Infinity
(NE050AC48ATEZ or NE075AC48ATEZ) Rectifiers
Figure 13-2C: Installing GP100 Series Rectifiers
Install Rectifiers
Caution: The rectifier latch is not a carrying handle
1. Open rectifier latch - press on latch release.
2. Side rectifier firmly into a rectifier position - oriented as shown.
3. Close latch until it clicks into place.
4. Turn on the AC breaker powering the shelf slot
5. Following initialization of the rectifier module, verify its green LED and only its green LED and only
its green LED is on.
6. If this isn’t the case, see the troubleshooting section.
To Next Page
Loading...
