ABB i-bus KNX User Manual

ABB i-bus
®
KNX
Commissioning
182 2CDC508134D0202 | FCA/S 1.x.x.1
Example: Maximum dead time of the input signal for a detected edge:
After detection of an edge on the input, further edges are ignored for the maximum dead time T
D
.
Enable communication object
"Block" 1-bit
Options:
No
Yes
 Yes: The 1-bit block communication object Block is enabled. This can be used to disable the input.
Notes
If the input is disabled and the option Send cyclically is set, the last state is still sent regardless of the
block. The option Block still blocks the physical input, sending continues internally.

ABB i-bus KNX Specifications

General

Brand	ABB
Model	i-bus KNX
Category	Controller
Language	English