4 Repair
4.4.6. Replacement of linkage - link
3HAC026048-001 Revision: A130
© Copyright 2006-2008 ABB. All rights reserved.
Required equipment
Press tool, link
The tool for fitting the bearing and the link to the upper arm shaft includes the parts shown in
the figure below (included in the toolkit for service).
Note! The parts cannot be ordered separately, but are included in the complete toolkit! The
article numbers are only given for identification!
xx0600002618
Equipment Spare part no. Art. no. Note
Protection hood 2522 2101-17 Replace if damaged!
VK-cover 3HAC12165-2 Replace if damaged!
Toolkit for service 3HAC023963-
026
A tool for pressing the bearing
and the link to the upper arm
shaft is assembled from the
loose parts in the kit.
The assembly is shown in the
figure Press tool, link on page
130.
Bearing grease 3HAB3537-1
Locking liquid - Loctite 243
Standard toolkit - The contents are defined in
section Standard toolkit on
page 190, in part 2 of the
Product manual.
Other tools and
procedures may be
required. See references
to these procedures in
the step-by-step instruc-
tions below.
These procedures include
references to the tools
required.
A Hydraulic cylinder, 3HAC11731-1
E Nut, 3HAC5507-1
O Connecting rod, 3HAC023081-003
P Press housing, 3HAC024097-002
Continued
Continues on next page
To Next Page
Loading...
