ABB Navigator 500 Series - First-Time Calibration (Single-Stream)

Navigator 500
Sodium analyzer 5 Calibration
22 OI/ASO550–EN Rev. G
5.2 Performing a calibration for the first time – single-stream wet-section
To perform a quick two-point calibration from an Operator page:
1. Press the key (below the Cal prompt).
The Calibrate page is displayed:
2. Press the key (below the Select prompt).
The Calibrate / Sodium 1 (2, 3, 4) page is displayed.
Use the / keys to select the wet-section to be
calibrated.
3. Press the key (below the Select prompt on the
Calibrate / Sodium 1 [2, 3, 4] page).
The Sodium 1 (2, 3 or 4) / Start Calibration page
is displayed:
4. Press the key (below the Yes prompt on the Start
Calibration page).
The Calibration page is displayed with a bar graph to
indicate calibration progress:
At the end of the calibration, and if the calibration is
successful, the Active Slope, Active Offset, Last Slope and
Last Offset values in the Signals View are updated – see
Section 6.6, page 33 for details of View modes.
5. To exit the Calibration page, press the key (below the
OK prompt). Calibration continues and calibration
progress can be monitored from the Calibration View –
see Fig. 5.1, page 24.
The Calibrate / Sodium page is displayed.
6. Press the key (below the Back prompt).
The Calibrate page is displayed:
7. Press the key (below the Exit prompt) to return to the
Operator page.
CAL
2012–04–15
10 : 34: 52
°C 21.7
21.7
2.93
Navigator
Tag 1
Na
ppb
Menu
Calibrate
Exit Select
Sodium 1
Calibrate
Back Select
Sodium 1
Start Calibration
Exit Yes
Note. The Active Slope and Active Offset values are
not updated if the calibration fails. The Calibration Log
is updated with the Active Slope and Active Offset
values.
PV 2.93
SS1 100
Sodium 1
Please Wait
Abort OK
ppb
ppb
Sodium 1
Calibrate
Back Select
Menu
Calibrate
Exit Select