Navigator 500
Sodium analyzer 7 Menu descriptions
50 OI/ASO550–EN Rev. G
7.1.4 Display
Used to select the display language, setup Operator page templates (1 to 5), enable diagnostic,
view and log functions, set the device’s display brightness / contrast and set the time and date.
Menu Comment Default
Language Selects the display language:
English / German / French / Italian / Spanish.
English
Operator Templates Enables a template to be assigned to a wet-section for display
purposes – refer to Section 6.5, page 31 for Operator Template
examples.
Page 1
Page 1 (to 5) Template Page 1 template cannot be set, this defaults to the number of
wet-sections connected.
Chart View The chart can be configured to display the trend for 1, 2, 3 or 4 PV
and / or temperature values. The engineering ranges for the values
are configured in the Sensor Setup menu – see page 46.
Note: This menu is displayed only when Chart View is Enabled at the
Operator Functions / Chart View.
Channel 1 (to 4)
Source Selects the signal (PV and temperature) to be displayed on the chart.
Tag A 3-character, alphanumeric tag used to identify the parameter on
the chart.
Chart Duration Selects the chart duration from 1, 2, 4, 8, 12, 16, 20 and 24 hours.
View/Log Enables Enables / disables the following View and Log functions:
View functions:
Diagnostics View / Signals View / Chart View / Alarm View / Analog
OP View – refer to Section 6.6, page 33 for examples of Operator
Pages in View mode.
Log functions:
Calibration Log / Alarm Log / Audit Log / Diagnostics Log – refer to
Section 6.7, page 34 for examples of Operator Pages in Log mode.
Continued on next page…
To Next Page
Loading...
