ABB Navigator 500 Series - Communication

Navigator 500
Sodium analyzer 7 Menu descriptions
56 OI/ASO550–EN Rev. G
7.1.8 Communication
Communication level menus are enabled only if an optional communications module is fitted.
Ethernet and Email menus enabled only if a Ethernet communications module is fitted.
Menu Comment Default
Profibus
Slave Address Sets the device-specific slave address for identification on the network.
Baud Rate A read-only value (range 0 to 12000 K) taken from the PC the network
is connected to.
Ethernet
DHCP Sets DHCP (Dynamic Host Control Protocol) on / off.
Set to On if the IP address is to be allocated dynamically by the
network.
Set to Off if the IP address is defined statically.
IP Address Sets the IP address to be assigned to the wet-section. The IP address
is used by the TCP/IP protocol to distinguish between different
devices.
The address is a 32-bit value expressed with 4 values (0 to 255), each
separated by a period (.).
Note. Configurable only if DHCP is disabled.
Subnet Mask The subnet mask is used to indicate which part of the IP address is
used for the network ID and which part is used for the host ID.
Set each bit that is part of the network ID as '1's, for example:
255.255.255.0 indicates the first 24 bits are for the network ID.
Default Gateway Sets the IP address for the Default Gateway (router or switch) used to
communicate with other networks.
Note. This setting is required only if a router (or switch) is used.
000.000.000.000
Email
SMTP Server ID The IP (Internet Protocol) address of the SMTP (Simple Mail Transport
Protocol) server used to distribute emails.
Recipients
Email Address 1 – 3 Enter the email address(es) of the recipient(s).
Triggers
Tag 1 – 4 The trigger description that appears in the subject title.
Source 1 – 4 Up to 4 independently-configurable triggers can be enabled to
generate an email when the selected source becomes active (the email
can be sent to up to 3 recipients).
Invert 1 – 4 If enabled, an email is generated when the Source becomes inactive
instead of active.
Menu
Communication
Exit
Select