Navigator 500
Sodium analyzer 6 Operation overview – transmitter
40 OI/ASO550–EN Rev. G
6.10 Display icons
6.10.1 Diagnostic icons 6.10.2 Title bar icons
Note.
When a diagnostic condition is detected the
associated NAMUR icon plus the highest priority
diagnostic message is displayed in the Status Bar
when the transmitter is in Operator View mode – refer
to Appendix A, page 72 for diagnostic messages.
If the status bar displays a diagnostic message, press
the key to see all diagnostic messages.
NAMUR icons
Diagnostic icon – Out of Specification.
Diagnostic icon – Maintenance Required.
Diagnostic icon – Failure.
Diagnostic icon – Check Function.
Alarm, Hold and Calibration icons
Alarm – indicates a user-defined alarm condition
(20-character) and flashes intermittently with an
associated NAMUR diagnostic icon.
Hold – indicates that alarms / analog outputs are
in a manual hold state.
Calibrating – indicates that a calibration is in
progress.
Log mode – indicates that one of the View pages
is currently displayed (Calibration, Alarm, Audit or
Diagnostic)
View mode – indicates that one of the View
pages is currently displayed (Diagnostics,
Alarms, Outputs, Signals or Chart).
Media on-line: 0 to <20 % full.
Media on-line: 20 to <40 % full.
Media on-line: 40 to <60 % full.
Media on-line: 60 to <80 % full.
Media on-line: 80 to <100 % full.
Media on-line: full (icon toggles when full).
Media off-line: 0 to <20 % full.
Media off-line: 20 to <40 % full.
Media off-line: 40 to <60 % full.
Media off-line: 60 to <80 % full.
Media off-line: 80 to <100 % full.
Media off-line: not inserted (not logging).
Media off-line: not inserted, logging active
– icon display toggles with Media off-line: not
inserted (not logging) icon.
To Next Page
Loading...
