ABB Navigator 500 Series - Navigation Overview; Operating Mode

Navigator 500
Sodium analyzer 6 Operation overview – transmitter
OI/ASO550–EN Rev. G 31
6.4 Navigation overview
6.5 Operating mode
In operating mode, values from connected wet-sections are displayed on Operator Pages. A maximum of 5 Operator Pages can be
displayed.
Operator Page 1 (the default page) displays values from all connected wet-sections simultaneously (a maximum of 4 wet-sections
can be connected). The remaining Operator Pages can be assigned to display values from individual wet-sections (in any wet-section
order). To achieve this, each wet-section must be associated with a template in the Configuration level / Display / Operator Templates
parameters – see page 50.
In Fig. 6.4, Operator Page 1 shows that 4 wet-sections are connected.
Fig. 6.3 Menu navigation
*The highest priority diagnostic or alarm is displayed. Other active diagnostic / alarm states can be viewed on the Diagnostics
View – see page 33.
Fig. 6.4 Operator Page 1 (sodium multiple wet-section)
Operator
Page 1
Operator
Page 2
Operator
Page 3
Operator
Page 4
Operator
Page 5
Diagnostics
View
Signals
View
Chart
View
Alarms
View
Outputs
View
Alarm
Log
Audit
Log
Calibration
Log
Diagnostic
Log
2.77
2.77
4.28
4.28
6.93
6.93
No UNa
8.82
8.82
2012–04–15
10 : 29: 17
CAL
Instrument tag
(user-assignable)
Time and date
Display icon –
see Section 6.10, page 40
Unit of measure
NAMUR (NE107) Status Icons
Failure High Process Alarm
Maintenance Low Process Alarm
Out of Spec High Latch Alarm
Check Function Low Latch Alarm
Display icon –
see Section 6.10, page 40
Diagnostic message or alarm tag –
see Appendix A, page 72 for diagnostic messages
Wet-section tag
(user-assignable)
Process value (PV)
Parameter ID
Autoscroll icon –
scrolls each page
sequentially when enabled
TAG 1
TAG 2
In Configuration
Navigator
TAG 3
ppb
ppb
ppb
Na
Na
Na
Na
ppb