Navigator 500
Sodium analyzer 6 Operation overview – transmitter
30 OI/ASO550–EN Rev. G
6.2 Transmitter operation modes
The transmitter has 4 modes of operation – all modes are accessed from the Operator menu – see Fig. 6.2.
Operating – used to display real-time wet-section values on Operating Pages – refer to Section 6.5, page 31.
View – used to display diagnostic messages, alarms, output values, signals (including the flow rate where applicable) and (chart)
traces – refer to Section 6.6, page 33.
Log – used to display recorded (diagnostic, calibration, audit) events and alarms – refer to Section 6.7, page 34.
Configuration – used to configure the transmitter – refer to Section 7, page 42.
6.3 Operator menus
Referring to Fig. 6.2, Operator menus A are accessed from any Operating, View or Log page by pressing the key B.
To select Operator sub-menus (indicated by the arrow) press the key C.
Operator menus comprise:
Operator Pages – displays the Operator Page for each available wet-section.
Data Views – displays enabled data views.
Logs – displays enabled Log views.
Alarm Acknowledge – acknowledges the active alarm displayed in the Alarms View.
Manual Hold – holds (freezes) the current outputs and alarms for the selected wet-section(s).
Autoscroll (enabled on Operator pages only) – displays Operator pages sequentially when multiple wet-sections are fitted.
Media Card – displays the status of the SD Card / USB stick (enabled only media module is fitted).
Enter Configuration – enabled on all pages – enters Configuration parameters via the Access Level – refer to Section 6.9.2,
page 39 for access levels and password security options.
CAL shortcut – initiates a calibration directly from an Operator Page, press the key C (below the CAL prompt). This shortcut
opens the Calibrate page, bypassing the Configuration level menus.
Note. Operator menus cannot be accessed directly from the Configuration level.
Fig. 6.2 Operator menus
Note. Active values are still indicated on the display.
In Configuration
CAL
A
B
C
Autoscroll
Manual hold
Enter Configuration
To Next Page
Loading...
