ABB NGC8200 - Analyzer Standard Hardware Features

12 | NGC8200 AND PGC1000 USER MANUAL | 2101510MNAH
Helium Carrier Consumption rate: 12 ml/minute typical to 20 ml/minute maximum
Medium 800 to 1500 Btu per standard Cubic Foot (29.8 to 44.6
megajoules/meter
3
) with less than 100 PPM H2S
Analysis time Approx. 5 minutes; interval between cycles is adjustable
Calibration/validation
streams
Up to 2 dedicated (reduces sample stream for each dedicated
calibration streams). Must use dedicated stream(s) for Auto-Cal
feature.
Sample streams Up to 4 (with manual calibration streams)
Construction NEMA/Type 4X (IP56)
Aluminum Alloy with white polyester powder coating.
Explosion-Proof, see specification sheet for certifications.
Installation time Requires 2-3 hours for installation, minimum 8 hours run time for
repeatability.
Mounting Pipe run, free-standing pipe, shelf, and environmental enclosure
NGC8200 and PGC1000
dimensions
Width Height Depth Weight
US 9.5 inches 8.82 inches 15.64 inches 29 lbs.
Metric
241.3 mm
224.0 mm
397.3 mm
10.8 kg
Notes:
1. Usually experienced at startup. Use this for power supply sizing requirements (includes approx.
20% buffer and is calculated for maximum allowable power supply voltages).
2. At recommended AC power supply voltage. Highly temperature dependent, with feed-through
heater operating continuously. Usually occurs at only the coldest ambient operating temperature, i.e.,
0 °F (-18 °C).
2.1 Analyzer standard hardware features
The analyzer features a rugged, field-ready design. Hardware features include:
 Enclosure
 Cast aluminum housing with six exterior hubs
 Powder coating
 Weatherproof construction
 Modular design (see Figure 2-1)
 Digital controller assembly
 Analytical module with compact design and single bolt replacement
 Feed-through assembly with flame path arrestors
 Termination panel
 Electronics
 32-bit digital controlling electronics (no analog control loops)
 Low power operation
 Dual digital carrier pressure regulation
 Digital temperature control
 Digital detector electronics
 Low EMI/RFI design
 Operates on Windows CE
 Auto-start with diagnostics
 Factory calibrated