2101510MNAH | NGC8200 AND PGC1000 USER MANUAL | 49
Figure 6-5: Cable for USB connection
Table 6-1: Cable for USB connection
Host system interface type Required cabling termination (connectors)
or adaptors
ABB part number
USB 2.0 Type A receptacle USB 2.0 Type B plug to USB 2.0 Type A plug
cable (referred as USB PCCU32 cable)
1801800-xxx
To set up communication using the USB port:
1. Connect the USB cable from the laptop to the analyzer: The cable’s client end (type B)
connects to the analyzer. The Host end (type A) connects to the laptop’s USB port.
2. Power on the analyzer. Observe the analyzer’s LCD initializing sequence. Diagnostic tests begin
immediately. See section 6.4 Power on sequence for details.
3. Launch PCCU: Locate and select the PCCU shortcut. The main PCCU screen displays.
Figure 6-6: Main PCCU32 screen (prior to connection with device)
4. Click Setup on the PCCU32 toolbar menu.
Figure 6-7: PCCU32 Connection Setup
To Next Page
Loading...
