2101510MNAH | NGC8200 AND PGC1000 USER MANUAL | 41
Figure 4-22: Vent line connections on feed-through assembly
4.7 Security seal
For some installations, it may be desirable to attach a security seal on the enclosure front and rear
end caps. To accommodate seal, note the holes located in the tab located on each end cap (see Figure
4-23).
Figure 4-23: End cap tabs for security seal
Customer-supplied materials:
1 each security wire seal
Seal press
To attach a security seal:
5. Insert security wire through holes located on end cap tabs.
6. Bring ends together and insert through holes in security seal (see Figure 4-24).
7. Use seal press to compress seal into wire. Ensure that the wire is firmly captured inside seal.
Figure 4-24: Security wire with seal
To Next Page
Loading...
