ABB NGC8200 - Table 6-2: Required Cables for Connection with MMI Port

2101510MNAH | NGC8200 AND PGC1000 USER MANUAL | 51
Figure 6-10: MMI-to-DB-9 (female) cable
Figure 6-11: USB-to-DB9 (male) Digi
®
Edgeport
®
/1 converter
Table 6-2: Required cables for connection with MMI port
Host system
(PC/Laptop)
port type
Required cabling termination (connec
tors) or
adaptors
ABB part number
Legacy serial
(
RS
-
232
)
interface, DB-9
(9-PIN, male connector)
1 cable/adapter required
:
Serial DB
-
9 (9 POS,
female connector) to circular military cable (referred
to as MMI cable)
2015240*
USB
2
converter/adapter cables required
:
 Serial DB-9 (9 POS, female connector) to circular
military cable
 Digi
®
Edgeport
®
/1 converter: Serial DB-9 (9 POS,
male connector)-to-USB cable)
2015240* and
1801382-001
*May be available in several lengths. The 8' cable is part number 2015240-004.
To set up communication using the MMI port:
1. For laptops with legacy COM1/COM2 interfaces, connect the MMI cable as follows:
a. Connect the circular miliary end to the MMI port on the analyzer.
b. Connect the DB-9 end to the laptop’s COM1 or COM2 port.
2. For laptops with USB ports only, use also the Digi
®
Edgeport
®
/1 converter. Connect the MMI
cable and converter as follows:
a. Connect the circular miliary end to the MMI port on the analyzer.
b. Connect the DB-9 end to the Digi
®
Edgeport
®
/1 converter’s DB-9 end.
c. Connect the Digi
®
Edgeport
®
/1 converter’s USB end to the laptop USB ports.
3. Power on the analyzer. Observe the analyzer’s LCD initializing sequence. Diagnostic tests begin
immediately. See section 6.4 Power on sequence for details.
4. Launch PCCU.
5. Click Setup on the PCCU32 toolbar.