2101510MNAH | NGC8200 AND PGC1000 USER MANUAL | 63
Figure 6-27: Stream Sequence
4. When all desired changes have been made, click Send and then Next to move to the next
screen.
IMPORTANT NOTE To enable or disable streams after completion of diagnostics, select Stream
Sequence from the Analyzer Operation screen. It is recommended that the diagnostic stream test
be performed on streams enabled after initial diagnostics. Select Help for additional information.
6.5.5 Update configuration
Save the device configuration file following setup:
1. At the Update Configuration tab, click on the value field next to Save Configuration Data
and click Now (Figure 6-28).
To Next Page
Loading...
