68 | NGC8200 AND PGC1000 USER MANUAL | 2101510MNAH
Figure 6-34: Process stream analysis running
2. Click Next.
6.5.9 Complete startup
The device should continue to cycle through all enabled streams, performing analysis and producing
data. If it was determined that calibration is required, it is recommended that the device be allowed to
run for at least eight hours before calibration to allow the device to stabilize.
To complete the Startup Wizard:
1. On the Complete tab, click Close to exit the wizard (Figure 6-35).
Figure 6-35: Final Wizard screen
After the wizard is closed, the Operation screen displays (Figure 6-36). For additional configuration
or operation of the analyzer click Show Tree View.
To Next Page
Loading...
