ABB NGC8200 - Page 137

2101510MNAH | NGC8200 AND PGC1000 USER MANUAL | 137
—
ABB Inc.
Measurement & Analytics
Quotes: US-IAMA.inquiry@us.abb.com
Orders: US-IAMA.order@us.abb.com
Training: US-IAMA.training@us.abb.com
Support: upstream.support@us.abb.com
+1 800 442 3097 (opt. 2)
Main Office - Bartlesville
7051 Industrial Blvd
Bartlesville, OK 74006
Ph: +1 918 338 4888
Texas Office - Houston
3700 W. Sam Houston
Parkway S., Suite 600
Houston, TX 77042
Ph: +1 713 587 8000
We reserve the right to make technical changes or modify the contents of this document without prior
notice. With regard to purchase orders, the agreed particulars shall prevail. ABB does not accept any
responsibility whatsoever for potential errors or possible lack of information in this document.
The content of these instructions is neither part of nor provided for changing a previous or existing
agreement, promise, or legal relationship. All obligations of ABB result from the respective sales
contract, which also contains the full and solely valid warranty clauses. These are neither limited nor
extended by the content of these instructions.
We reserve all rights in this document and in the subject matter and illustrations contained therein.
Any reproduction, disclosure to third parties or utilization of its contents - in whole or in parts – is
forbidden without prior written consent of ABB.
Armstrong
®
is a registered trademark of Armstrong International.
Edgeport
®
is a registered trademark of Digi International Inc.
Genie
®
is a registered trademark of A+ Corporation.
Modbus
®
is a registered trademark of Modicon.
®
Phoenix
®
is a registered trademark of Phoenix Contact GmbH & Co.KG
Teflon
®
is a registered trademark of MOXA.
Windows
®
is a registered trademark of Microsoft.
2101510MNAH
Copyright
©
2023 ABB all rights reserved