ABB NGC8200 - Page 3

2101510MNAH | NGC8200 AND PGC1000 USER MANUAL | 3
4.3.2 Pipe saddle installation for pipe saddle mounting ............................................ 26
4.3.3 Shelf installation ....................................................................................... 26
4.3.4 Analyzer installation .................................................................................. 27
4.4 Sample system installation ...................................................................................... 28
4.4.1 Sample system design considerations .......................................................... 28
4.4.2 Tube quality ............................................................................................ 28
4.4.3 Maintaining phase ..................................................................................... 29
4.4.4 Sample probe installation ........................................................................... 29
4.4.5 Sample conditioning modules...................................................................... 30
4.4.6 Sample line connections............................................................................. 34
4.5 Carrier and calibration system installation.................................................................. 36
4.5.1 Calibration/validation stream ...................................................................... 36
4.5.2 Cylinder rack installation on meter run ......................................................... 36
4.5.3 Carrier gas regulator installation ................................................................. 36
4.5.4 Calibration gas regulator installation ............................................................ 37
4.5.5 Carrier gas and calibration gas line connections ............................................. 39
4.6 Vent lines connections ............................................................................................ 40
4.7 Security seal......................................................................................................... 41
5 Wiring ........................................................................................................................ 42
5.1 Wire for serial communication ................................................................................. 42
5.2 Wire for power and grounding ................................................................................. 42
5.2.1 Power supply requirements ........................................................................ 43
5.2.2 Operating voltages and cable lengths ........................................................... 43
5.2.3 Other considerations ................................................................................. 44
5.2.4 Ground the analyzer .................................................................................. 44
5.2.5 Cathodic protection ................................................................................... 44
5.2.6 Wire the analyzer power connector .............................................................. 44
6 Startup ....................................................................................................................... 45
6.1 Download PCCU32 from the ABB website ................................................................... 45
6.2 Install PCCU32 ...................................................................................................... 47
6.3 Establish initial local communication ......................................................................... 48
6.3.1 Connect using USB port (standard) .............................................................. 48
6.3.2 Connect using RS-232 port ......................................................................... 50
6.3.3 Connect using Ethernet port ....................................................................... 52
6.4 Power on sequence ................................................................................................ 55
6.4.1 Initialization............................................................................................. 55
6.4.2 Startup diagnostics ................................................................................... 55
6.5 Startup wizard ...................................................................................................... 57
6.5.1 Set up the station ..................................................................................... 59
6.5.2 Set up the stream ..................................................................................... 59
6.5.3 Set up calibration ..................................................................................... 61
6.5.4 View diagnostics ....................................................................................... 62
6.5.5 Update configuration ................................................................................. 63
6.5.6 Analyze the calibration stream .................................................................... 64