Human-Machine Interface (HMI)
Chapter 6
70
1SFC132003M0201
6:2.4 Local Control menu
The Local Control menu is used to start or stop the motor
from the keypad. When a type of local control is selected the
softstarter can only be controlled by the keypad.
The softstarter operation state (stopped/running) remains
when selecting local control until it is changed there.
Previous type of control is activated again when the local
control is exited.
Three different selections are possible (see the table below).
Press navigation keys to view different types of control.
The LOCAL CONTROL menu can not be entered if Sequence
start is selected.
Once the motor has been started in this menu, it must first be
stopped before you leave the menu. If the motor is already
running when the menu is entered it is possible to leave
immediately without stopping the motor.
6:2.4.1 Start/Stop the motor
Start
Enter the Start/Stop menu, figure 22.
Select Start. The motor will now start and run according to
the set parameters.
Stop
Select Stop. The motor will stop according to the set
parameters. It is possible to press stop command during the
start ramp if required.
Top level
igure 21: Local control menu
Settings
Local Control
Event Log
Status Information
Reset Events
Start/Stop
Jog
DOL Start
Function Description
Start/stop To start and stop the motor with
the keypad.
Jog To run the motor as long as Jog is
pressed.
DOL start
(PSTB370...PSTB1050
only)
To start and stop the motor with
the built-in by-pass contactor.
Figure 22:Start/Stop menu
Top level
Settings
Local Control
Event Log
Status Information
Reset Events
Start/Stop
Jog
DOL Start
To Next Page
Loading...
