ABB PST210 - Basic Settings

Settings and configuration
Chapter 7
90
1SFC132003M0201
7:2.3 Basic Settings
The Basic settings menu consists of the most common start/
stop parameters required for the set-up. Each parameter can
be adjusted separately. For a deep description of each
parameter, see Chapter 10 “Functions” .
Enter the Basic settings
Enter the menu by selecting Basic Settings.
Setting I
e
Set the current that the softstarter will be exposed to i.e.
rated motor current, if the unit is connected In Line.
For units connected Inside Delta the Setting I
e
must be set
according to the current in the delta circuit = 58% ( )
of the rated motor current.
Press Store to save the data after setting the current.
External By-Pass contactor (Ext ByPass)
Set the parameter to Yes if an external by-pass contactor is
used, or else No. This parameter is not available on
PSTB370...1050 since these have an integrated by-pass
contactor.
Press Store to save the data.
Start mode
Select the type of ramp that will be used during start. The
possible options are:
•Volt
• Torque
Press Store to save the data after setting the start ramp type.
Stop mode
Select the type of ramp that will be used during stop. The
possible options are:
•Volt
• Torque
Press Store to save the data after setting the stop ramp type.
Application
Settings
Basic
Settings
Functional
Settings
Service
Settings
Presentation
Settings
All
Settings
Changed
Settings
Reset all
Settings
F
igure 24: Basic Settings menu
Top level
Settings
Operation
Mode
13()⁄