ABB PST210 - Page 89

Settings and configuration
Chapter 7
89
1SFC132003M0201
Tuning parameters
Nine parameters can be tuned individually if a more specific
adjustment is required. Each parameter is described in
Chapter 10 “Functions” .
• Start mode
• Stop mode
• Start ramp
• Stop ramp
• Initial voltage
•End voltage
• Step down voltage (Not available if Stop mode is set to
Torque)
• Current limit level
• Torque limit (Not available is Start mode is set to Volt)
When all tuning parameters have been passed, following
information will be displayed, figure 23. Select Yes if all
necessary parameters are tuned. If a new tuning is required
select Back and follow the step Tune Set above.
Ready?
Yes Back
F
igure 23: All tuning parameters
have been passed