ABB REB670 Series - Setting guidelines; Single point generic control 8 signals SPC8 GAPC; Identification; Application

12.7.3 Setting guidelines
SEMOD55398-5 v5
The function does not have any parameters available in the local HMI or PCM600.
12.8 Single point generic control 8 signals SPC8GAPC
SEMOD176448-1 v3
12.8.1 Identification
SEMOD176456-2 v3
Function description IEC 61850
identification
IEC 60617
identification
ANSI/IEEE C37.2
device number
Single point generic control 8 signals SPC8GAPC - -
12.8.2 Application
SEMOD176511-4 v7
The Single point generic control 8 signals (SPC8GAPC) function block is a collection of 8 single
point commands that can be used for direct commands for example reset of LED's or putting
IED in "ChangeLock" state from remote. In this way, simple commands can be sent directly to
the IED outputs, without confirmation. Confirmation (status) of the result of the commands is
supposed to be achieved by other means, such as binary inputs and SPGAPC function blocks.
PSTO is the universal operator place selector for all control functions. Even if
PSTO can be configured to allow LOCAL or ALL operator positions, the only
functional position usable with the SPC8GAPC function block is REMOTE.
12.8.3 Setting guidelines
SEMOD176518-4 v7
The parameters for the single point generic control 8 signals (SPC8GAPC) function are set via
the local HMI or PCM600.
Operation : turning the function operation On / Off .
There are two settings for every command output (totally 8):
PulseModex : decides if the command signal for output x is Latched (steady) or Pulsed .
tPulsex : if PulseModex is set to Pulsed , then tPulsex will set the length of the pulse (in
seconds).
12.9 AutomationBits, command function for DNP3.0
AUTOBITS
SEMOD158589-1 v3
1MRK 505 370-UEN D Section 12
Control
Busbar protection REB670 333
Application manual