ABB RED650 Applications Manual

A
B
C
Z
0m
Z
0m
Z
0
-
Z
0m
Z
0
-
IEC09000253_1_en.vsd
IEC09000253 V1 EN-US
Figure 56: Equivalent zero sequence impedance circuit of the double-circuit,
parallel, operating line with a single phase-to-earth fault at the
remote busbar
When mutual coupling is introduced, the voltage at the relay point A will be
changed according to equation 37.
0 0
0
0 1
1 3 3
3 1 3 1
m
L L
ph p
ph L
L L
Z
Z Z
U Z I I I
Z Z
æ ö
-
= × + × +
ç ÷
× ×
è ø
IECEQUATION1276 V3 EN-US (Equation 37)
By dividing equation 37 by equation 36 and after some simplification we can write
the impedance present to the relay at A side as:
3 0
1 1
3 0
æ ö
×
= +
ç ÷
+ ×
è ø
L
I KNm
Z Z
I ph I KN
EQUATION1277 V3 EN-US (Equation 38)
Where:
KNm = Z0m/(3 · Z1L)
The second part in the parentheses is the error introduced to the measurement of
the line impedance.
If the current on the parallel line has negative sign compared to the current on the
protected line, that is, the current on the parallel line has an opposite direction
compared to the current on the protected line, the distance function will overreach.
If the currents have the same direction, the distance protection will underreach.
Maximum overreach will occur if the fault current infeed from remote line end is
weak. If considering a single phase-to-earth fault at 'p' unit of the line length from
A to B on the parallel line for the case when the fault current infeed from remote
line end is zero, the voltage U
A
in the faulty phase at A side as in equation
39.
U p ZI I K I K I
A
L ph N Nm p
= ⋅ + ⋅ + ⋅
( )
3 3
0 0
IECEQUATION1278 V2 EN-US
(Equation 39)
Section 7 1MRK 505 393-UEN B
Impedance protection
116 Line differential protection RED650 2.2 IEC
Application manual

ABB RED650 Specifications

General

Brand	ABB
Model	RED650
Category	Protection Device
Language	English