Configuring GOOSE inputs with the IEC 61850
Configuration tool................................................................... 34
Configuring GOOSE with IET600..................................................... 35
Defining devices and exporting the SCD file for IET600............. 36
Creating an empty project with IET600....................................... 38
Importing the SCD file into IET600.............................................. 39
Configuring a GOOSE publisher with IET600............................. 40
Creating a GOOSE data set with IET600...............................40
Configuring a GOOSE control block with IET600...................43
Configuring a GOOSE subscriber with IET600........................... 46
Configuring GOOSE inputs with IET600................................ 46
Finalizing GOOSE configuration with IET600..............................47
Exporting the SCL file.............................................................47
Importing the SCL file.............................................................48
Connecting GOOSE inputs to a relay application.............................50
Received GOOSE message handling.............................................. 52
GOOSE supervision......................................................................... 53
Background sending....................................................................53
Default value handling................................................................. 53
Alarm supervision in application.................................................. 54
Diagnostic counters..................................................................... 54
Forcing of GOOSE signals .............................................................. 57
Testing of one device.................................................................. 57
Testing of many devices in a system ..........................................58
Section 6 Process bus and IEEE 1588 time synchronization........ 61
Sampled measured values and IEEE 1588 v2 time
synchronization.................................................................................61
System building................................................................................ 61
High-availability seamless redundancy HSR...............................61
Parallel redundancy protocol PRP...............................................63
Performance optimization............................................................64
Requirements for third party devices...........................................64
SMV system configuration................................................................65
Configuring SMV with the IEC 61850 Configuration tool.............66
Configuring SMV with IET600..................................................... 67
Bay level configuration..................................................................... 69
Application configuration of the SMV receiver.............................69
SMV control block .......................................................................72
Angle and amplitude corrections................................................. 73
SMV delay................................................................................... 73
IEEE 1588 v2 parameters and status information....................... 74
Power profile parameters............................................................ 77
Quality bits in SMV frames.......................................................... 78
Table of contents
2 REC615 and RER615
Engineering Guide
To Next Page
Loading...
