ABB Relion REC615 - Creating Report Control Blocks with the IEC 61850 Configuration Tool

7.4 Creating report control blocks with the IEC 61850
Configuration tool
1. Select the IED node in Plant Structure in Project Explorer.
2. Click the Report Controls tab.
3. Right-click the area containing the existing report control blocks and select New
to add a new report control block.
GUID-184CB65D-000A-4825-965A-406BF345C7AB V1 EN
Figure 58: Adding a new report control block
4. Browse to LLN0 under LD0 to define where to place the report control block.
5. Give a unique name to the report control block.
6. In the drop-down list, select the previously created data set to link with the GCB.
Section 7 1MRS757809 C
Engineering of event reporting with PCM600
90 REC615 and RER615
Engineering Guide