GUID-3D82B39F-D86C-4E99-9AB7-DC3105E6DFE6 V1 EN
Figure 53: Engineering mode selection button
When the engineering mode is enabled, SCD files from external
IEC 61850 engineering tools cannot be imported into PCM600.
3. Switching IEC 61850 IED naming on and off
The button switches between IEC 61850 and PCM600 IED naming.
4. Create new object.
The button opens a window to create a new object. The type of object depends on
the currently selected engineering type.
5. Selection details
The button opens the Editor window for the data currently selected in the
mapping grid. The same editor can also be opened by double-clicking the data.
6. Receiving access points
All IEDs that have access points capable of receiving the kind of data according
to the currently selected engineering type and engineering mode are displayed as
columns in the mapping grid. A check mark in a column means that the access
point is receiving the data.
7. Mapping grid
Mapping grid consists of check boxes for configuring what data is sent to or
received by an access point. A check mark in the grid means that the data on the
row is sent to the receiver in the column.
8. Data to send/receive
The data available for sending/receiving in the selected engineering mode and
type is displayed as rows in the mapping grid. The data is context-sensitive, with
the current selection in the PCM600 plant structure. A check mark in the row
means that the data is sent to or received by an access point. Double-click a data
to open the data editor.
9. Engineering type selection
Each engineering mode has several engineering types. Engineering type means
the type of data to configure. The types can be selected by clicking the tab page
on the bottom of the tool window. The available engineering types depend on the
selected engineering mode.
• Data sets: Create, delete, modify or send data sets
• GOOSE controls: Create, delete, modify or send GOOSE controls
• Sampled value controls: Create, delete, modify or send GOOSE controls
• Report controls: Create, delete, modify or send report controls
• Inputs: View inputs (external references)
10. Object properties
The Object Properties window displays the properties of the currently selected
data. Different data properties are edited in this window.
Section 7 1MRS757809 C
Engineering of event reporting with PCM600
86 REC615 and RER615
Engineering Guide
To Next Page
Loading...
