CTRL.LLN0 Local/remote state (also present in DNP IIN-
bits).........................................................................................18
LD0.LLN0 Settings supervision..............................................19
LD0.LOFLPTUC1 Loss of load protection..............................19
LD0.MAPGAPC1 Multipurpose analog protection
function (1).............................................................................19
LD0.MAPGAPC2 Multipurpose analog protection
function (2).............................................................................19
LD0.MAPGAPC3 Multipurpose analog protection
function (3).............................................................................19
LD0.MAPGAPC4 Multipurpose analog protection
function (4).............................................................................20
LD0.MAPGAPC5 Multipurpose analog protection
function (5).............................................................................20
LD0.MAPGAPC6 Multipurpose analog protection
function (6).............................................................................20
LD0.MDSOPT1 Generic operation time supervision..............20
LD0.MNSPTOC1 Negative-sequence overcurrent
protection for motors (1).........................................................20
LD0.MNSPTOC2 Negative-sequence overcurrent
protection for motors (2).........................................................21
LD0.MPTTR1 Motor thermal overload protection...................21
LD0.MVGAPC1 Multipurpose binary inputs (1)......................21
LD0.MVGAPC2 Multipurpose binary inputs (2)......................21
LD0.NSPTOV1 Negative-sequence overvoltage
protection - stage 1.................................................................22
LD0.PHIPTOC1 Phase overcurrent protection -
instantaneous stage 1 ...........................................................22
LD0.PHLPTOC1 Phase overcurrent protection - low
stage 1 ...................................................................................22
LD0.PHPTUV1 Phase undervoltage protection - stage
1.............................................................................................22
LD0.PSPTUV1 Positive-sequence undervoltage
protection - stage 1.................................................................23
LD0.PREVPTOC1 Phase reversal protection .......................23
DR.RDRE1 Disturbance recorder..........................................23
LD0.RESCMMXU1 Residual current limit supervision...........23
LD0.RESVMMXU1 Residual voltage limit supervision...........23
LD0.SEQRFUF1 Fuse failure protection................................24
LD0.SPCGGIO2 Multipurpose binary outputs - status
(2)...........................................................................................24
LD0.SSCBR1 Circuit-breaker condition monitoring................24
LD0.STTPMSU1 Motor startup supervision...........................25
LD0.TCSSCBR1 Trip circuit supervision (1)..........................25
LD0.TCSSCBR2 Trip circuit supervision (2)..........................25
Table of contents
2 REM615
Point List Manual
To Next Page
Loading...
Need help?
General
